Assembly instructions for your design

Included mounting hardware:

✓ Design
✓ Screws
✓ Dowel
✓ Spacers
✓ Magnets

Required tools:

🔧 Pen
🔧 Screwdriver (Phillips)
🔧 Drill ø 4-5mm

Assembly in 5 easy steps

[1.] Determine position
Hold the design in the desired position on the wall. Tip: It's best to work in pairs to avoid slipping and potential wall discoloration.

[2.] Mark and drill
First, place the design against the wall. Using a pencil, mark the top drill hole. Remove the design and drill a hole (35mm deep) at the marked spot.

[3.] Insert dowels
Insert the supplied dowel into the drilled holes in the wall.

[4.] Attach design

• Insert a screw through one of the two holes in the design.

• Slide a spacer sleeve onto the screw from behind.

• Loosely screw the design to the wall.

• Align the design, mark and drill the second hole, insert the dowel, and mount the screw and spacer sleeve as before.

• Tighten both screws by hand (not too tight, so as not to deform the material).

→ Torque and speed when screwing with a cordless screwdriver:

- Low torque: Select lower setting

(For 40Nm / 18V / 1.5Ah cordless screwdriver: Stage 4)

[5.] Attach magnets

Magnets also serve as spacers to the wall and can be positioned on the back of the design as needed.

✓ Done! Your design is now securely mounted. Enjoy!

Please check your assembly with these two pictures...

...to ensure maximum security and accuracy .

Validity notice:

Images may differ from the delivered product. Errors and changes due to technical advancements are reserved.